SKU
10061220080000

Medal of the Recognition of the Nation
Reduction

€31.50
  • Available in store
    Address : 2 bis rue Guénégaud, 75006 Paris
    More
More Information
Metal FLORENTINE BRONZE
Weight 2.3 g
Diameter 14 mm
Artisanal Manufatcure Metal : Yellow Bronze 14 mm Ribbon : sand colour striped with indigo blue rafters front: depicts the Republic effigy, surrounded by the engraved mention French Republic Backside: the mention "Medal of the Recognition of the...
main product photo
Medal of the Recognition of the Nation Reduction
€31.50

    Description

    • Artisanal Manufatcure
    • Metal : Yellow Bronze 14 mm
    • Ribbon : sand colour striped with indigo blue rafters

    front: depicts the Republic effigy, surrounded by the engraved mention French Republic

    Backside: the mention "Medal of the Recognition of the Nation" topped with a oak leaf bouquet. Can hold five clips:  "1914-1918 ", " 1939-1945 ", " Indochina ", "Northern Africa" and " Ecternal Operations".

    Our craftman

    • THE ENAMELLER

      Our creations are enamelled using a rare technique known as grand feu enamelling. Another workshop sends the enameller a decoration, piece of jewellery or struck medal with hollow spaces on its surface. Using a dip pen, needle or brush, the enameller fills these hollows with enamel, which they have prepared themselves. The fixing of the variously coloured enamel powders is controlled by short, successive firings at 900 degrees.

    • THE MEDAL MINTER

      The medal minter transforms a blank into a medal, alternating between striking to bring out the relief and annealing to return the metal to a more malleable state. The blank is struck as many times as necessary, depending on the diameter, depth and detail of the engraving. Finally, surface treatments are applied to enhance the finished piece

    • THE ENGRAVER

      Trained at the best schools, they have the years of experience behind them necessary to master all aspects of the craft. Using industrial oil-based modelling clay and working from a design executed freehand or with CAD software, they skilfully fashion a low relief model in order to enhance the engraving and the way it catches the light. They work alternately with concave and convex plaster moulds until satisfied they have achieved the best 3D rendering of the design.

    ×