SKU
10060052150000

Cross of Military Value
Full Size

€29.00
  • Available in store
    Address : 2 bis rue Guénégaud, 75006 Paris
    More
More Information
Metal FLORENTINE BRONZE
Weight 16 g
Diameter 32 mm
Home-made Manufacturing Metal : bronze Ribbon : red with a three white stripsMedal sold with its case  Obverse : medal of 32 mm diameter, the effigy of the Republic was put on by a helmet and was decorated with branches of laurels surround...
main product photo
Cross of Military Value Full Size
€29.00

    Description

    • Home-made Manufacturing
    • Metal : bronze
    • Ribbon : red with a three white strips
    • Medal sold with its case 
    Obverse : medal of 32 mm diameter, the effigy of the Republic was put on by a helmet and was decorated with branches of laurels surrounded with the inscription "French Republic".
    Reverse : a two-edged sword clocks below, beams surrounding the high part at the level of the handle and the inscription " Cross of the Military value " 

    Our craftman

    • THE ENAMELLER

      Our creations are enamelled using a rare technique known as grand feu enamelling. Another workshop sends the enameller a decoration, piece of jewellery or struck medal with hollow spaces on its surface. Using a dip pen, needle or brush, the enameller fills these hollows with enamel, which they have prepared themselves. The fixing of the variously coloured enamel powders is controlled by short, successive firings at 900 degrees.

    • THE MEDAL MINTER

      The medal minter transforms a blank into a medal, alternating between striking to bring out the relief and annealing to return the metal to a more malleable state. The blank is struck as many times as necessary, depending on the diameter, depth and detail of the engraving. Finally, surface treatments are applied to enhance the finished piece

    • THE ENGRAVER

      Trained at the best schools, they have the years of experience behind them necessary to master all aspects of the craft. Using industrial oil-based modelling clay and working from a design executed freehand or with CAD software, they skilfully fashion a low relief model in order to enhance the engraving and the way it catches the light. They work alternately with concave and convex plaster moulds until satisfied they have achieved the best 3D rendering of the design.